Registered protocol family 10 [ 9. You are holding it across the entire open, close, read, write, ioctl, and it is protecting a bunch of different things. USB Mass Storage device detected [ 1. This code can handle multiple interrupt events at once. EHCI orion driver [ 0.

Uploader: Mak
Date Added: 12 June 2016
File Size: 70.55 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 26157
Price: Free* [*Free Regsitration Required]

Installation for booting from NAND. Initial device info thread: Except where otherwise noted, content on this wiki is licensed under the following license: Yes, this can be happened.

USB hub found [ 0. Registered protocol family 2 [ 0. This link has some good information on writing the kernel to the nand, and this link shows how to write a ubifs image from u-boot.

TK71 Marvell Kirkwood: Ka-Ro electronics GmbH

Regards, Michail Michail Kurachkin 4: Will do it later when I will be able to test kirksood as I currently have no suitable hardware. Why do you think this is the case? In addition to these the two LEDs can also be repurposed.


I thought about that. OK OK Starting kernel And one struct device more for the whole SLIC.

staging: Support of TDM bus, TDM driver for Marvell Kirkwood and SLIC driver for Silabs Si3226x

Failed to request enable GPIO Driver reg-fixed-voltage requests probe deferral [ 0. The pad closest to the processor is tied to the pin. Testing write buffer coherency: Can anyone verify this? gdm

Mem malloc Initialization 8M – 7M: I tested such condition and it works ok. A single function would prevent the code duplication. Nand installation of ubifs Instructions for trunk, but also work for CC User Tools Register Log In. Below is an image with the ones I’ve found so far.

Make sure your serial device is 3. You are holding it across the entire open, close, read, write, ioctl, and it is protecting a bunch of different things. Seems strange to have MISO as output only, could be other errors? Hi guys, Thanks for your comments.


Here is the hardware peripheral mapping http: Proceed kigkwood caution as you risk bricking your device. JTAG access points are available on the back side of the board. For each of them I created one struct device. Note that if you have serial console, you don’t need the ssh access which the above instructions call for.

USB Mass Storage device detected [ 1. This klrkwood has been compiled from various sources and has not been verified.

Baud rate is